CRUISE-MATE MOTORCYCLE CRUISE CONTROL INSTALLATION INSTRUCTIONS FOR
BOSS HOSS MOTORCYCLES.
(Images coming soon)

1.      Loosen throttle cable adjusting lock nut and back off cable adjuster.

2.      Remove throttle cable housing bolts.

3.      Remove throttle cable from grip and unscrew from cable housing.

4.      Locate bottom center of throttle cable housing cavity from inside housing and drill a 1/8 hole through housing.

5.      Flip housing over and using the 1/8^th hole as a guide drill a 21/64^th hole in housing from the outside.

a.       Drill 21/64^th hole from the outside of throttle housing to avoid damaging chrome with drill.

6.      Tap 21/64^th hole with 3/8-24 tap.

a.       Be careful to remove all chips from inside of housing to avoid chips entering throttle cable when reassembled.

7.      Apply Loctite to outside of Cruise-Mate bushing.

8.      Screw Cruise-Mate bushing into throttle housing and tighten.

9.      Back Cruise-Mate out of throttle housing far enough to remove tension from wave spring.

10.  Reinstall throttle housing on bike and adjust throttle cable to operating position.

11.  Screw Cruise-Mate into throttle housing until you just feel pressure against throttle tube.

12.  Apply a small amount of Loctite to threads of shoulder screw and install handle, handle spring and shoulder screw on Cruise-Mate insert.

You're now ready to adjust Cruise-Mate for operation, go here for adjusting procedures.